Pinzgauer Vector 718 6×6 Armoured Patrol Vehicle

Pinzgauer Vector 718 6×6 Armoured Patrol Vehicle The Vector is based on the Pinzgauer (6 x 6) chassis which has been fitted with a new armoured body The armoured floor offers greater blast and roll over protection The torsion resistant central tube chassis incorporates the transfer case and lockable differentials with portal hubs on swing axles offering enhanced mobility All vehicles are in a right-hand drive configuration with the vehicle commander normally occupying the left seat. Transparent armour windows are provided for forward and side observation with driver and commander being provided with a forward opening door. The troop compartment is at the rear and normally consists of four people who can rapidly enter and leave the vehicle via two doors in the rear of the vehicle. The seats are fitted with 4 point harness seat belts. Additional seating in the rear could be fitted if required Each of these doors is provided with a vision block to provide observation over the rear of the vehicle. There are also two large hatches in the roof which will allow two of the crew to have good all round observation. A searchlight is mounted on the forward part of the roof which is controlled from within the vehicle. Standard equipment includes power-assisted steering, anti-skid braking system, electronic traction control, run flat tyres and air conditioning system. Standard equipment includes steps to front doors, grab handle for front passenger, exterior rear view mirrors, brush guard, fuel tank guard, fuel filter in tube, water separator, and NATO pintle towing device.